I have noticed that my home server is strangely using lots of swap (~5 GB), despite having only a few lightweight processes running and loads of RAM installed (32 GB).

Upon configuring Grafana + Prometheus, I noticed a trend where cache + buffer will progressively increase until swap starts to be used. My system and services combined will use ~8 GB RAM. Upon rebooting, the cache + buffer will start anywhere from 3–10 GB, progressively ramp up to ~25 GB in 1–2h, where swap will start to be needed (~3 GB). See the image attached for reference.

My swap filesystem is on an expensive (to me) SSD, and I would like to reduce its wear by as much as possible. I understand that swap can introduce only minimal wear on SSDs depending on its nature and that it can be harmless, but I am still not sure what is causing this behavior (and why) and whether I should worry about it or not. So I figured I should investigate what is happening here.

My main question is, how can I figure out what is causing this behavior? Is it expected? I am looking for guidance from others who are more experienced than me in the topic.

A little bit about my system:

I am running Debian 12 on an NVMe SSD containing the root partition (btrfs) and docker services. I also have two HDDs, one with persistent data (ext4), and the other with backups (ext4). This is majoritarily a single-user machine. I tried using the following kernel parameters, but it hasn’t helped:

vm.swappiness=10
vm.vfs_cache_pressure=200

My docker services are:

  • *arr stack
  • jellyfin
  • nextcloud
  • immich
  • open-webui + ollama
  • pi-hole
  • invidious
  • romm
  • nginx proxy manager
  • grafana + prometheus
  • other minor services that I don’t think are doing much (uptime-kuma, stirlingpdf, vaultwarden, etc)
  • jet@hackertalks.comEnglish
    2·
    3 hours ago

    In my production systems, and in my home systems, and in my gaming computers, I turn swap off. There’s no good reason to wear out disc writes. In production systems, I’d rather have something fail hard, then get slower and slower and slower falling behind.

    Quite frankly, there’s no good reason to have swap on anymore, memory is huge. Most programs don’t need as much as they use. You can set memory pressure in systemd, telling programs to reduce their usage, and giving them individual hard cutoffs, so something like Prometheus can’t take down your whole system just because it’s got a memory leak.