Hey, folks! I had begun configuring VLANs recently, and I’ve got two managed switches between my firewall and my mini PC. I set up a 10 VLAN on the third octet with a /24 mask, and the idea is that anything on 10 should be able to reach the internet but not VLAN 1, while VLAN 1 should be able to access the internet and VLAN 10 services. I’m not so crazy as to try to start with that configuration though. No ports or anything are exposed yet, so my first test was just going to be full access between networks. I maybe counted my initial configuration as a success too soon, because with the mini PC on the 10 network, I can reach the gateway at 192.168.10.1 but nothing else. I can even access the OPNsense config page at the 10 gateway address. If I ping 192.168.1.1, I get “Network is unreachable”. If I ping www.google.com, I get “Temporary failure in name resolution”, and I also can’t pull up sites like YouTube. And again, this is all with a VLAN rule that I believed to be configured to allow all traffic, as it mimics what’s set up for my default LAN interface. Pinging the mini PC from the 1 VLAN also fails; it just sort of times out with 100% packet loss, so perhaps the default rule is less permissive than I thought, but it does say it allows all.
I’ve been following beginner guides from the Home Network Guy (a name that makes this stuff sound more approachable than how he actually presents it), but even with a video that’s not even 3 years old, pieces of OPNsense have been deprecated and replaced with new components such that I can’t follow along verbatim. For instance, it was an ordeal to get DHCP working now that the one he used has been replaced with Dnsmasque DNS and DHCP, and I can’t even tell you what I changed that eventually got it working, but my first couple of tries did not. In one of those videos I’ve been following, he indicates that the default rule on the LAN interface will allow full access between all networks, but that doesn’t seem to be the case, as the same settings on the other VLAN aren’t allowing them to talk to one another.
Obviously, I don’t intend to leave full access between the networks when it’s time to go live, but this simple smoke test shows that there’s a gap in my understanding if I can’t get what should be the easiest test to work. Does anyone know what I’m missing or what I should do to troubleshoot from here?
No. I didn’t use any video’s to set mine up and wouldn’t even know where to find one that is up to date.
Dnsmasq isn’t being deprecated that I know of but when you begin doing more advanced functions some tools work better than others. The “New” rules are fully functional and I suspect the old ones will slowly be removed in later releases. They are revamping some stuff, ISC DHCP used to be the go to but that is being passed out by the creators. https://www.isc.org/kea/ and OPNsense is cleaning up things so it all works with the rest api and is higher performance.
Trunking is when a port can deal with all setup vLAN’s not sure about your switches as they are pretty basic looking. I’m using a pair of Dell PowerConnect 5548’s and a Quanta LB6M which are much more complex. But basically think of a vLAN as a branch of a tree and the Trunk is the base that connects to everything.
I don’t see myself needing more advanced functions, and at this point I’d be happy to get the basic ones working, haha.
I understand the concept of a trunk port, but I don’t know how to translate that into some other terminology that my manual uses instead, or if there’s some other paradigm. To the best of my knowledge, it’s the difference between a tagged port and an untagged port, which I think I have configured correctly. I must be at least in the ballpark if I can hit the gateway and nothing else.