I’ve seen so many 10" servers that look amazing from the front and very polished, but then having a rats nest of cables and a mess at the back.

After 62 iterations and many 3D prints, blood, sweat, profanity and tears. I my design and implementation is finally done. image

This is Before: image

And the After: image
The ducky adds 200MHz

The front of my mini-rack is actually still somewhat of a mess, I thought I’d focus on the back first.

I’ve published it in excruciating detail on my GitHub Leave a Star if you like what you see

    • Legion739@piefed.zipOPEnglish
      0·
      2 hours ago

      I don’t think I understand your question.

      If you plug all your servers into a power strip like this, all the power goes through the power strip and through one cable. If there is a fault in the power strip, all the servers will lose power as a fuse will trip.

      The same is true for my setup, I have added no new failure modes.