I’m looking to buy some security cameras for my mother in law. I currently have a small server with plenty of storage at my place that I’d prefer to use on at least a temporary basis to keep costs down. Are there any self hostable cameras that support a built in VPN? I currently use tailscale for my network but I’m open to learning something else. Alternatively, can they run over a tailscale subnet router? I don’t use that yet but if I could place a cheap node in her place to help her access footage and my other services via subnet routing I’ll do that too.
Reolink stores to a SD card with the option to upload to FTP backups.
I suspect a big 128 gb card would be good enough without off-site storage.
Alternatively, can they run over a tailscale subnet router?
Yes, the cameras wouldn’t need to be aware of tailscale (or a VPN), you’d just put a pi or install tailscale on a PC there and expose the cameras over the subnet router config to your server also on tailscale.
I did this using a router to handle traffic for about a year between sites 240 miles apart. The only downside was it used a lot of bandwidth. Maybe it can be done with some IP cameras, but I expect they’d be expensive commercial models. OpenWRT compatible routers can be dirt cheap.
If your MIL’s router supports OpenWRT or you can replace it with one that does, you can use a VPN and PBR (Policy Based Routing) to your home router or server and do exactly what you want with any camera that supports RSTP (Real Time Streaming Protocol). That includes most cheap wired TP-Link cameras and plenty of others. PBR on the router at your MIL’s home would be used to route all traffic from camera IP addresses to your server.
I used Frigate software and Home Assistant for occupancy detection/alerts and Wireguard for transport. It worked perfectly but I eventually got around to adding 2nd server.
I just want to throw out there the idea of using Eufy cameras for older people. The systems store offline you don’t have to pay for online storage etc. And the app and everything is very simple and easy to use.
I know it’s not what you’re asking but I went through a similar dilemma with my MIL and went this route because she struggles enough as it is with technology.
If you’re using Frigate with docker you could route the container through a gluetun container.
This. A VPN is just a network route. Applications can’t tell the difference between a local subnet and a VPN.
