• SaveTheTuaHawk@lemmy.ca
      link
      fedilink
      English
      arrow-up
      2
      ·
      4 hours ago

      Most of downtown Toronto has been cooled by deep lake water in Lake Ontario since 2004. Cuts electricity use by 75%.

    • Skyrmir@lemmy.world
      link
      fedilink
      English
      arrow-up
      5
      ·
      10 hours ago

      Just realize the hole he dug is probably the bare minimum to handle the heat load from the smallest window AC. It takes a lot of digging to cool a real AC unit. And European homes aren’t known for have large yards.

      • Bytemeister@lemmy.world
        link
        fedilink
        English
        arrow-up
        5
        ·
        9 hours ago

        You can dig straight down, and run the ground loop vertically, but it’s surprisingly expensive to dig the hole. Like 15-40k expensive.

        • Skyrmir@lemmy.world
          link
          fedilink
          English
          arrow-up
          3
          ·
          9 hours ago

          I gotta say I understand the cost. Dig a full size grave by hand some time. It’s freakin exhausting. And sure, an excavator can do it in minutes, but that means you’re paying for time on a very expensive machine.

      • grandma@sh.itjust.works
        link
        fedilink
        arrow-up
        3
        ·
        9 hours ago

        There’s places with district heating from back in the days that people still invested in new infrastructure. We could do the same with cooling but I’m afraid the neoliberal rot has penetrated too far at this point.

        • Skyrmir@lemmy.world
          link
          fedilink
          English
          arrow-up
          2
          ·
          9 hours ago

          Heating is easier than cooling. For heat you just run a set of lines from the source to the homes, same as plumbing. To dump that heat into the ground, the field you need grows very quickly. A small town would need a large, and probably deep field of pipes. The cost would be huge. Geothermal is great, but digging is hard, so it’s relatively expensive. Every project needs to be individually considered, to determine if it’s really the way to go.